Shop / Japandi Photo holder
Japandi Photo holder
A long holder for a card, photo or birth announcement, with printed stems that slot in beside it. Finely ribbed edge.
Incl. VAT. Shipping calculated at checkout.
A holder with a groove running its full length. Set a card in it, a photo, or a birth announcement. Because the groove runs all the way across, two fit side by side.
The printed stem is included and fits the same groove, next to the card. The outer edge is finely ribbed and the top stays smooth, so the attention goes to what's in it rather than to the holder.
On a mantelpiece, a bookshelf, or beside the flowers on the table. Keep it indoors, out of direct sunlight. Over time the sun will fade the colour, and sustained heat can warp PLA.
Printed just for you. See the terms for returns and right of withdrawal.